Safety precautions for operation of stone cutting machine
- before work
1, wear good work clothes, wear good goggles, female long hair will wear a cap.
- Power knife switch, tightness of saw blade, saw blade guard cutting machine or safety baffle should be checked in detail. The operating table must be stable for laser cutting machine, and sufficient lighting should be provided for night operation. — can correctly use power tools such as jackhammer drill, portable cutter and portable grinder; — can complete the installation and construction of common doors, Windows, air conditioning decorative louvers, light steel keel, ceiling, railings, escalators, etc. and adjust them in place according to the operating procedures of product installation process; use the operating procedures of stone cutting machine and accessories of copying cutting machine.
- Turn on the master switch, make several turns in no-load test, and only after it is confirmed to be safe can it be started.
work
- Operation with gloves is strictly prohibited. Wear a mask or mask if dust may develop during operation.
- Do not try to cut small workpieces not clamped by saw.
- This machine only allows cutting profiles.
4, do not carry out strong cutting saw operation, before cutting to make the motor to reach full speed.
- No one is allowed to stand behind the bridge saw machine.
- Do not lean over or around the saw machine. Do not loosen any hand or raise arm from the saw or workpiece until the saw blade stops.
- Do not operate without the protective cover in place, and do not place your hand within 15cm from the saw blade belt sander.
- Power supply must be cut off before repair or replacement of accessories, and wait for the saw blade to stop completely.
- If abnormal sounds are found, the inspection should be stopped immediately.
After work
- Turn off the main power supply of the electric circular saw
- Clean and tidy the work table and site
- In case of personal and equipment accidents, the site shall be maintained and reported to relevant departments.
